Category:GsiLab

From Fab Lab Wiki - by NMÍ Kvikan
Revision as of 08:28, 7 February 2013 by Emmanuel Gilloz (Talk | contribs)

Jump to: navigation, search

Draft

Pense-bete avant création d'une page

Makko CNC

600x390x120mm

  1. Préparer un .dxf avec Pycam, renommer la fin du fichier exporté en .nc
  2. Mettre la machine sous tension
  3. Lancer le logiciel "Key"
  4. Ouvrir le .nc
  5. Définir les vitesse de plongée et avance
  6. Surveiller que la machine s'initialise correctement
  7. Définir l'origine de la pièce
  8. Lancer la broche
  9. Lancer l'usinage (sans cocher "broche éteinte", "truc continu", "pas à pas")

Subcategories

This category has the following 3 subcategories, out of 3 total.

Pages in category "GsiLab"

The following 11 pages are in this category, out of 11 total.