Difference between revisions of "Makko-640/fr"
From Fab Lab Wiki - by NMÍ Kvikan
(Created page with "{{languages|Makko-640}} Category:GsiLab Category:CNC ==Capacités== ==Utilisation==") |
m |
||
(2 intermediate revisions by the same user not shown) | |||
Line 2: | Line 2: | ||
[[Category:GsiLab]] | [[Category:GsiLab]] | ||
[[Category:CNC]] | [[Category:CNC]] | ||
+ | |||
+ | [[File:Makko-640.png|thumb|right|300px]] | ||
==Capacités== | ==Capacités== | ||
+ | |||
+ | 600 x 390 x 120mm | ||
+ | |||
+ | bois, aluminium | ||
==Utilisation== | ==Utilisation== | ||
+ | |||
+ | #Préparer un .dxf avec Pycam, renommer la fin du fichier exporté en .nc | ||
+ | #Mettre la machine sous tension | ||
+ | #Lancer le logiciel "Key" | ||
+ | #Ouvrir le .nc | ||
+ | #Définir les vitesse de plongée et avance | ||
+ | #Surveiller que la machine s'initialise correctement | ||
+ | #Définir l'origine de la pièce | ||
+ | #Lancer l'usinage (sans cocher "broche éteinte", "truc continu", "pas à pas") |
Latest revision as of 07:47, 2 September 2013
English • Deutsch • français • español • íslenska • 日本語 • Nederlands • norsk bokmål • galego • føroyskt • Türkçe •
Capacités
600 x 390 x 120mm
bois, aluminium
Utilisation
- Préparer un .dxf avec Pycam, renommer la fin du fichier exporté en .nc
- Mettre la machine sous tension
- Lancer le logiciel "Key"
- Ouvrir le .nc
- Définir les vitesse de plongée et avance
- Surveiller que la machine s'initialise correctement
- Définir l'origine de la pièce
- Lancer l'usinage (sans cocher "broche éteinte", "truc continu", "pas à pas")