User:Allifreyr

From Fab Lab Wiki - by NMÍ Kvikan
Revision as of 14:45, 25 October 2013 by Allifreyr (Talk | contribs)

Jump to: navigation, search

Valdi áfangan vegna þess að ég hef áhuga á forritun, tölvutækni og tölvuleikjum.

Hef áhuga fyrir því að prófa allt sem er hérna og sjá hvort ég sé með einhvern áhuga á því. Ég hallast samt að því að læra forritun eða kerfisfræði seinna.

 /*
 Blink
 Turns on an LED on for one second, then off for one second, repeatedly.

 This example code is in the public domain.
 */
 // Pin 13 has an LED connected on most Arduino boards.
 // give it a name:
 int tomato = 12;
 int kotl = 11;
 int rubick = 10;
 // the setup routine runs once when you press reset:
 void setup() {                
 // initialize the digital pin as an output.
 pinMode(tomato, OUTPUT);
 pinMode(kotl, OUTPUT);
 pinMode(rubick, OUTPUT);
 }
 // the loop routine runs over and over again forever:
 void loop() {
 digitalWrite(tomato, HIGH);   // turn the LED on (HIGH is the voltage level)
 delay(200);               // wait for a second
 digitalWrite(tomato, LOW);    // turn the LED off by making the voltage LOW
 delay(200);               // wait for a second
 digitalWrite(kotl, HIGH);   // turn the LED on (HIGH is the voltage level)
 delay(200);               // wait for a second
 digitalWrite(kotl, LOW);    // turn the LED off by making the voltage LOW
 delay(200);               // wait for a second
 digitalWrite(rubick, HIGH);   // turn the LED on (HIGH is the voltage level)
 delay(5000);               // wait for a second
 digitalWrite(rubick, LOW);    // turn the LED off by making the voltage LOW
 delay(200);  
 digitalWrite(kotl, HIGH);   // turn the LED on (HIGH is the voltage level)
 delay(200);               // wait for a second
 digitalWrite(kotl, LOW);    // turn the LED off by making the voltage LOW
 delay(200);               // wait for a second
 }