Difference between revisions of "User:Frosti/3dscanning"
From Fab Lab Wiki - by NMÍ Kvikan
(New page: ==3D scanning with Next Engine== * Enter the Scan Panel by clicking the Scan button * 360: **- Select the "360" scan option in the scan panel to scan the object from every angle. **- ...) |
|||
| Line 1: | Line 1: | ||
| − | |||
| − | |||
==3D scanning with Next Engine== | ==3D scanning with Next Engine== | ||
| − | + | Setup | |
| + | Controls | ||
| + | ===Scan === | ||
* Enter the Scan Panel by clicking the Scan button | * Enter the Scan Panel by clicking the Scan button | ||
* 360: | * 360: | ||
| Line 16: | Line 16: | ||
**- Place object 17 inches from the front of the scanner | **- Place object 17 inches from the front of the scanner | ||
| − | + | ===Align=== | |
*Click on Align | *Click on Align | ||
*Alignment for 360 | *Alignment for 360 | ||
**- Place 1 pin on a common location between 2 scans within the family. | **- Place 1 pin on a common location between 2 scans within the family. | ||
**- Drag the pin to the location or double click on the point to place the pin. | **- Drag the pin to the location or double click on the point to place the pin. | ||
| + | |||
| + | ===Trim=== | ||
| + | ===Fuse=== | ||
| + | ===Polish=== | ||
| + | ===Orient=== | ||
| + | ===Measure=== | ||
| + | ===Output=== | ||
Revision as of 14:29, 2 March 2010
Contents
3D scanning with Next Engine
Setup Controls
Scan
- Enter the Scan Panel by clicking the Scan button
- 360:
- - Select the "360" scan option in the scan panel to scan the object from every angle.
- - The number of divisions will control the degree of rotation between scans and the total number of
scans
- - The individual scans will be grouped as a family.
I had a thing that was about 250 mm height, so I chose
- Wide = 0.015" accuracy, 10x13" field of view
- - Place object 17 inches from the front of the scanner
Align
- Click on Align
- Alignment for 360
- - Place 1 pin on a common location between 2 scans within the family.
- - Drag the pin to the location or double click on the point to place the pin.
