From Fab Lab Wiki - by NMÍ Kvikan
Jump to: navigation, search

Snap fit BOX

You can create different kind of boxes by using snap fit. First you set the grid units (spacing x and y) from document properties, in my case it was 4 mm because I used mdf. Then you can draw a square and fill it and make sure that the stroke paint is off.


My first little box :) Vector setting was speed 10, power 100, freq 500 and DPI 400.


I also started to do another box and I´m planning to put some figures or pictures in each side, but this project is still unfinished.