User:Tankzter/playing with a 3d object

Here I started a 3d project where I make use of 3d modeling in two part for two different colors using dual print extrusions of the 3d printer,

I also print it out in ABS so I can put it into acetone vapor bath to remove the layer liner of the print and get a smoother finish

The object itself in whole is a pot-lid handle as an replacement for a one that broke

• The process
• 
  Inside of Tinkercad (3d program) I create the 3d objects, (there is a hole for the small object and for a screw)
• 
  Here you can see that the Smaller 3d object does not sit on the bigger object but has a hole and sits in it
• 
  Inside the Makerbot software I start with by inserting the larger 3d object that´s also the base for the other 3d object and setting it to left extrusion for black filament (shown as red color)
• 
  Then insert and I align the smaller 3d object into the bigger one so it fits perfectly and setting it to right extrusion for the white filament
• 
  Inside Preview: Here we can see the layers, Time on printing and weight of the print
• 
  Here I look at layer 91, just to confirm that the print will do alright on each object
• 
  Here it is out of the 3d printer (printed in ABS with Low settings)
• 
  Here it is filed down to make it smoother
• 
  Here it is inside a glass container with paper drenched in acetone liquid creating acetone vapors
• 
  Here it is out of the vapors after about 3 hours

• 
  And here it is complete after puting it back in for another 3 hours (not much different)