: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 1: | Line 1: | ||
[[Image:Viktorr 1.jpg|thumb|left|150px| | [[Image:Viktorr 1.jpg|thumb|left|150px|Viktor Rittmüller]] | ||
| Line 20: | Line 20: | ||
== FAB103 Projects == | == FAB103 Projects == | ||
[[Image:Viktorr 2.jpg|thumb|right|200px|BMW Keychain]] | |||
My first project in [[FAB103]] was to make a keychain in [http://www.fablab.is/w/index.php/Inkscape Inkscape] with the [[Epilog Laser]]. I wanted to make a BMW keychain, a circle with the logo rastered into it. | My first project in [[FAB103]] was to make a keychain in [http://www.fablab.is/w/index.php/Inkscape Inkscape] with the [[Epilog Laser]]. I wanted to make a BMW keychain, a circle with the logo rastered into it. | ||
Revision as of 10:46, 3 October 2011
Viktor Rittmüller (20).
I am half icelandic and half german. I am a student in FAB103 on the Westman Islands (Iceland).
FAB103 Projects
My first project in FAB103 was to make a keychain in Inkscape with the Epilog Laser. I wanted to make a BMW keychain, a circle with the logo rastered into it.
First I simply found an image of the BMW logo and imported it into Inkscape. On my first attempt to cut it, I saw that I made the mistake having the entire image at 0,01 mm width stroke style. This made the laser cut out all the letters in the logo when I only wanted the circle.
So I made an identical circle as another layer over the BMW logo and disabled the stroke style on the logo itself. Then the outcome was as I had hoped.