Robust Kossel

This project focuses on improving the reliability, print quality and speed of a Revision A Folgetech Kossel. Before reading more it may be useful to make yourself familiar with [Delta Robots https://en.wikipedia.org/wiki/Delta_robot]

Goals

The main goals of this project are:

• Creating an enclosure for the print volume to reduce warping when printing large ABS parts.
• Modifying the effector to allow Z probing using the print nozzle as the probe to reduce the amount of error when measuring the offsets between where the printer thinks the bed is and where the bed actually is.
• Converting the rails to rollers to increase the maximum print height and reduce the rolling resistance of the carriage.
• Converting the stock direct drive extruder to a geared wades extruder to allow more a consistent feed of the filament into the hot end and shortening the bowden tube to give more precise retracts.

Heated Enclosure

Error creating thumbnail: /bin/bash: line 1: /usr/bin/convert: No such file or directory Error code: 127

Render of a The Kossel with doors

The heated enclosure will be made from sheets of perspex, as long as the temperature of the inside the volume is not too high the enclosure be robust enough to keep the hot air inside. The enclosure will be heated by the hot end and heated bed of the 3D printer.

The enclosure will also have to allow the extruder of the printer to be mounted and pass the bowden tube through the sheet.

Currently I am designing a simplified mockup of the printer to give accurate measurements when designing the sheets of perspex.

Probless Effector

The effector is the part that the hot end tool mounts to. Most commonly to measure the distance to the bed automatically, a probe is attached to the effector and the offset between the nozzle and the probe is a known measurement. With these two measurements the printer can calculate where the bed is, without the nozzle touching the bed.

In a probeless setup the hot end nozzle is the probe. This means that the offset between the nozzle and the probe is 0 in every direction and will improve the accuracy of the probing as the offset cannot be inaccurate.

By using an optical switch instead of a mechanical switch the accuracy is further improved. Subjectively, it felt like the mechanical switch preiously used reset at a different height than it activated.

The design used can be seen in this thingiverse page .

Rails to Roller Conversion

The Rails supplied with the kit restrict the maximum distance to the length of the rails instead of height of the frame. By replacing the rails the maximum Z height can be increased.