Fabacademy/machine making: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
images row |
||
| Line 1: | Line 1: | ||
We made Mantis 9,1: | We made Mantis 9,1: | ||
[[Image:2010_05_03_126_machine_crop_minni.JPG|thumb|400 px|Machine]] | |||
[[Image:2010_05_03_125_machine_crop_mnni.JPG|thumb|400 px|Machine]] | |||
[[Image:2010_05_03_124_machine_crop_minni.JPG|thumb|400 px|Machine]] | |||
Here are instructions and step by step instructions in making the Mantis 9.1 | Here are instructions and step by step instructions in making the Mantis 9.1 | ||
*[http://makeyourbot.org/start http://makeyourbot.org/start] | *[http://makeyourbot.org/start http://makeyourbot.org/start] | ||
| Line 18: | Line 20: | ||
[[Image:2010_05_03_131_paralell_2_minni.JPG|thumb|400 px|3 axis parallel port interface 1.0]] | [[Image:2010_05_03_131_paralell_2_minni.JPG|thumb|400 px|3 axis parallel port interface 1.0]] | ||
[[Image:2010_05_03_130_paralell_1_minni.JPG|thumb|400 px|3 axis parallel port interface 1.0 ]] | [[Image:2010_05_03_130_paralell_1_minni.JPG|thumb|400 px|3 axis parallel port interface 1.0 ]] | ||
[[Image:2010_05_03_119_cables_minni.JPG|thumb|400 px|Cables]] | [[Image:2010_05_03_119_cables_minni.JPG|thumb|400 px|Cables]] | ||
[[Image:2010_05_03_116_xyz_motor_minni.JPG|thumb|400 px|XYZ_board]] | [[Image:2010_05_03_116_xyz_motor_minni.JPG|thumb|400 px|XYZ_board]] | ||
Revision as of 14:42, 3 May 2010
We made Mantis 9,1:
Here are instructions and step by step instructions in making the Mantis 9.1
We did have inventory.
Spindle making
- For the spindle making we used the low cost spindle 1.0 http://makeyourbot.org/low-cost-spindle-1-0
The 3 axis motor
- This is the stepper motor we use for the 3 axis sleds [1]
Board making
You'll need to make four different types of circuit boards:
- QTY 1 Fabnet Adaptor Board (076-000a) [2]
- QTY 1 Stepper Motor Controller (076-001) [3]
- QTY 1 H-Bridge (076-004) [4]
- QTY 3 D.Carr Driver Boards A3982-1.0 [5]
- QTY 1 3 axis parallel port interface 1.0 [6]
FabNet
serialport = self.open_serial_port(fabnet_port, 38400, 0.2) -> serialport = self.open_serial_port(fabnet_port, 19200, 0.2)
Software
Questions and thoughts
- How do we combine
- before making the spindle ->
- On the Fab Net, suggestion, to help debugging, it would be good to have leds on transmit and receive, to be able to see if we are transmitting information or not.