*To confirm the scanning conditions again, click '''Scan'''.
*To confirm the scanning conditions again, click '''Scan'''.
Scanning starts.
Scanning starts.
===3 D Scanner Cola scanner ===
Project with Saethor Vido based on the idea of the [http://www.instructables.com/id/Milkscanner-V1.0/ Milk Scanner] . Since we didn't get the program to work on that site we copied the ideas based on our knowledge.
* Put item in container.
* Take picture (use tripod and keep the camera still)
* Pour fluid with contrasting color to the item, 0,5 dl
* Take picture after every filling until you have filled above the item.
* Use [[Gimp]] or other photo editor to increase contrast set images in monochrome
* Use [[Inkscape]] or other 2D Vector program to trace bitmap and turn it to vector.
- Select the "360" scan option in the scan panel to scan the object from every angle.
- The number of divisions will control the degree of rotation between scans and the total number of
scans
- The individual scans will be grouped as a family.
I had a thing that was about 250 mm height, so I chose
Wide = 0.015" accuracy, 10x13" field of view
- Place object 17 inches from the front of the scanner
Align
Click on Align
Alignment for 360
- Place 1 pin on a common location between 2 scans within the family.
- Drag the pin to the location or double click on the point to place the pin.
Trim
Fuse
Polish
Orient
Measure
Output
Results
3D scanning with Modela, Dr.Picza
Connect the 3D scanner tool with the Modela
Load the object to be scanned on the 3D scanner
Start Dr. Picza
Choose the communicaton port
Click File -> Preferences
Choose the communication port. (e.g. COM1)
Click OK
Set the scanning conditions
Choose Scanning Area:
Make the settings for X scan pitch and Y scan pitch
X scan pitch:
Y scan pitch:
Z -Bottom : Set the height of the Z reference surface.
Double click to make the sensor descend at this location
Z-upper limit.
Set the upper limmit for the height of the scanning area
Double click to check out if the right point is selected.
You can test all points by clicking them or click on Begin Area Test
After determining the scanning area, click OK
To confirm the scanning conditions again, click Scan.
Scanning starts.
3 D Scanner Cola scanner
Project with Saethor Vido based on the idea of the Milk Scanner . Since we didn't get the program to work on that site we copied the ideas based on our knowledge.
Put item in container.
Take picture (use tripod and keep the camera still)
Pour fluid with contrasting color to the item, 0,5 dl
Take picture after every filling until you have filled above the item.
Use Gimp or other photo editor to increase contrast set images in monochrome
Use Inkscape or other 2D Vector program to trace bitmap and turn it to vector.
