Difference between revisions of "Automated central tire inflation system"
From Fab Lab Wiki - by NMÍ Kvikan
| Line 1: | Line 1: | ||
| − | + | '''Project date: September 2014''' | |
'''Design made by: Björgvin Rúnar Þórhallsson''' | '''Design made by: Björgvin Rúnar Þórhallsson''' | ||
| Line 8: | Line 8: | ||
''I am working on a project at Reykjavik University to design and build an automatic control system for central tire inflation system for Icelandic glacier jeeps. The purpose of the devise is to increase traveling speed in challenging off road conditions and increase lifetime of tires of modified jeeps. The project is now in design and build phase but is expected to be finished in December 2014. The printed circuit board for the device was milled in the Roland Modela MDX-20 located at Fablab Breiðholt.'' | ''I am working on a project at Reykjavik University to design and build an automatic control system for central tire inflation system for Icelandic glacier jeeps. The purpose of the devise is to increase traveling speed in challenging off road conditions and increase lifetime of tires of modified jeeps. The project is now in design and build phase but is expected to be finished in December 2014. The printed circuit board for the device was milled in the Roland Modela MDX-20 located at Fablab Breiðholt.'' | ||
| + | |||
| + | [[File:2014-10-04 12.29.12.jpg|400px]] | ||
| Line 13: | Line 15: | ||
== Making a PCB == | == Making a PCB == | ||
| − | |||
'''Step 1. prepare design & lasercut.''' | '''Step 1. prepare design & lasercut.''' | ||
Revision as of 14:25, 5 October 2014
Project date: September 2014
Design made by: Björgvin Rúnar Þórhallsson
Design made at: Fab_Lab_Reykjavík with the [ Roland Modela MDX-20 | PCB milling machine]].
I am working on a project at Reykjavik University to design and build an automatic control system for central tire inflation system for Icelandic glacier jeeps. The purpose of the devise is to increase traveling speed in challenging off road conditions and increase lifetime of tires of modified jeeps. The project is now in design and build phase but is expected to be finished in December 2014. The printed circuit board for the device was milled in the Roland Modela MDX-20 located at Fablab Breiðholt.
Contents
Making a PCB
Step 1. prepare design & lasercut.
