Difference between revisions of "Soldering"
From Fab Lab Wiki - by NMÍ Kvikan
(New page: Use right heat for soldering. Before you solder the components, you should clean your board or use flux. We are soldering to make the components touch the board. We want to have everyt...) |
|||
| Line 19: | Line 19: | ||
* start shiny-ing the soldering iron with heating it up and coating it with saughter. | * start shiny-ing the soldering iron with heating it up and coating it with saughter. | ||
* | * | ||
| + | |||
| + | |||
| + | [[Category:Tutorials]][[Category:Circuits]] | ||
Revision as of 23:27, 14 January 2010
Use right heat for soldering.
Before you solder the components, you should clean your board or use flux.
We are soldering to make the components touch the board.
We want to have everything shiny.
We have different types of methods.
- Method 1 - Pin by pin
- Method 2 - Flood and suck
- Method 3 - Solder paste
- Desoldering SMD
Steps
- Tape down the board
- start shiny-ing the soldering iron with heating it up and coating it with saughter.
