Difference between revisions of "Soldering"
From Fab Lab Wiki - by NMÍ Kvikan
| Line 7: | Line 7: | ||
We want to have everything shiny. | We want to have everything shiny. | ||
| + | For more information on good soldering and bad soldering go [[here]] | ||
Revision as of 09:12, 15 January 2010
Use right heat for soldering.
Before you solder the components, you should clean your board or use flux.
We are soldering to make the components touch the board.
We want to have everything shiny.
For more information on good soldering and bad soldering go here
We have different types of methods.
- Method 1 - Pin by pin
- Method 2 - Flood and suck
- Method 3 - Solder paste
- Desoldering SMD
Steps
- Tape down the board
- start shiny-ing the soldering iron with heating it up and coating it with saughter.
