Difference between revisions of "Soldering"
From Fab Lab Wiki - by NMÍ Kvikan
| Line 20: | Line 20: | ||
* Tape down the board | * Tape down the board | ||
| − | * Heat the iron to around | + | * Heat the iron to around 640-740 fahrenheit = 340 celsius - 400 celsius |
| + | |||
* clean the board with A small towel with spritt ,notice that I said towel,thats because if you use tissue paper your circuit board is always going to wana ripp the tissue and leave tissue particlas left on your board | * clean the board with A small towel with spritt ,notice that I said towel,thats because if you use tissue paper your circuit board is always going to wana ripp the tissue and leave tissue particlas left on your board | ||
Revision as of 09:51, 15 January 2010
Use right heat for soldering.
Before you solder the components, you should clean your board or use flux (or both ,witch is really good).
We are soldering to make the components combined to the circuit board.
We want to have everything shiny.
For more information on good soldering and bad soldering go here.
We have different types of methods.
- Method 1 - Pin by pin
- Method 2 - Flood and suck
- Method 3 - Solder paste
- Desoldering SMD
Steps
- Tape down the board
- Heat the iron to around 640-740 fahrenheit = 340 celsius - 400 celsius
- clean the board with A small towel with spritt ,notice that I said towel,thats because if you use tissue paper your circuit board is always going to wana ripp the tissue and leave tissue particlas left on your board
- start shiny-ing the soldering iron with heating it up and coating it with saughter.
