Difference between revisions of "User:Gísli/Make something big"
(→Pokertable) |
(→Pokertable) |
||
Line 23: | Line 23: | ||
- How to make- | - How to make- | ||
I cutted out the two ply wood boards and glued sponge on the upper one than I stretched the black vinil over the sponge and stabled it to the ply wood (did same to the lower one but with felt and no sponge).Then I Made holes in the red felt for the leds and rasterd "Royal Flush" (best hand in poker) in 6mm plexiglass.When that was all dun I laid the cable on the board and screwed it together from the bottom side of the table.Later when I have time I want to upgrade the table by putting cup holders under the table so you can slide them out. | I cutted out the two ply wood boards and glued sponge on the upper one than I stretched the black vinil over the sponge and stabled it to the ply wood (did same to the lower one but with felt and no sponge).Then I Made holes in the red felt for the leds and rasterd "Royal Flush" (best hand in poker) in 6mm plexiglass.When that was all dun I laid the cable on the board and screwed it together from the bottom side of the table.Later when I have time I want to upgrade the table by putting cup holders under the table so you can slide them out. | ||
− | [[Image:P2222222.JPG|thumb|200 px| | + | [[Image:P2222222.JPG|thumb|200 px|]] |
− | -Final product- | + | In Progress |
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | -Final product- | ||
[[Image:Pokerbord1.jpg|thumb|200 px|left ]] | [[Image:Pokerbord1.jpg|thumb|200 px|left ]] | ||
[[Image:Pokerborð2.jpg|thumb|200 px|left ]] | [[Image:Pokerborð2.jpg|thumb|200 px|left ]] |
Revision as of 12:59, 24 November 2009
Pokertable
This is a project that i already started at fablab 203 in school and finished in Fab Academy 09' I Made a pokertable and this is the materials that are needed:
12" and 15" 2,75*122 ply wood boards.
Red felt.
Black vinil.
Plexiglass.
Ultrabright led lights.
Few meters of christmas lightcables.
A stable gun.
Sponge.
Strong glue.
- How to make-
I cutted out the two ply wood boards and glued sponge on the upper one than I stretched the black vinil over the sponge and stabled it to the ply wood (did same to the lower one but with felt and no sponge).Then I Made holes in the red felt for the leds and rasterd "Royal Flush" (best hand in poker) in 6mm plexiglass.When that was all dun I laid the cable on the board and screwed it together from the bottom side of the table.Later when I have time I want to upgrade the table by putting cup holders under the table so you can slide them out.
In Progress
-Final product-
Tool Box
-Final product-