Revision as of 13:11, 24 November 2009

Pokertable

This is a project that i already started at fablab 203 in school and finished in Fab Academy 09' I Made a pokertable and this is the materials that are needed:

12" and 15" 2,75*122 ply wood boards.

Red felt.

Black vinil.

Plexiglass.

Ultrabright led lights.

Few meters of christmas lightcables.

A stable gun.

Sponge.

Strong glue.

                                                                                - How to make-

I cutted out the two ply wood boards and glued sponge on the upper one than I stretched the black vinil over the sponge and stabled it to the ply wood (did same to the lower one but with felt and no sponge).Then I Made holes in the red felt for the leds and rasterd "Royal Flush" (best hand in poker) in 6mm plexiglass.When that was all dun I laid the cable on the board and screwed it together from the bottom side of the table.Later when I have time I want to upgrade the table by putting cup holders under the table so you can slide them out.

                                                        In Progreslefts
                                                       

Figuring out where the leds would show. outer

                                                                           -Final product-

Tool Box

-Final product-

Error creating thumbnail: