Difference between revisions of "User:Gísli/Make something big"
(→Corner shelf) |
(→Corner shelf) |
||
Line 177: | Line 177: | ||
=Corner shelf= | =Corner shelf= | ||
+ | |||
+ | This was a pretty easy project that I made for my garage here are the drawings -> | ||
+ | |||
+ | |||
[[Image:DSC02684.JPG|thumb|200 px|left|Behind the shelf is the waist material ]] | [[Image:DSC02684.JPG|thumb|200 px|left|Behind the shelf is the waist material ]] | ||
[[Image:DSC02686.JPG|thumb|200 px|left ]] | [[Image:DSC02686.JPG|thumb|200 px|left ]] | ||
[[Image:DSC02685.JPG|thumb|200 px|left ]] | [[Image:DSC02685.JPG|thumb|200 px|left ]] |
Revision as of 13:21, 25 November 2009
Pokertable
This is a project that i already started at fablab 203 in school and finished in Fab Academy 09' I Made a pokertable and this is the materials that are needed:
12" and 15" 2,75*122 ply wood boards.
Red felt.
Black vinil.
Plexiglass.
Ultrabright led lights.
Few meters of christmas lightcables.
A stable gun.
Sponge.
Strong glue.
- How to make-
I cutted out the two ply wood boards and glued sponge on the upper one than I stretched the black vinil over the sponge and stabled it to the ply wood (did same to the lower one but with felt and no sponge).Then I Made holes in the red felt for the leds and rasterd "Royal Flush" (best hand in poker) in 6mm plexiglass.When that was all dun I laid the cable on the board and screwed it together from the bottom side of the table.Later when I have time I want to upgrade the table by putting cup holders under the table so you can slide them out.
-In the making-Cutting out the inner plank and behind me is the outer one.
-Final product-
Tool Box
File:Verkfæraskápur.pdf This is the file so If you are intrested you can print it out ;)
Corner shelf
This was a pretty easy project that I made for my garage here are the drawings ->